An I/O port is usually used as a technical term for a specific address on the x86's IO bus. This bus provides communication with devices in a fixed order and size, and was used as an alternative to memory access. On many other architectures, there is no predefined bus for such communication and all communication with hardware is done via memory-mapped IO. This also increasingly happens on modern x86 hardware.
Looking for a list of ports
As an operating system developer, you should not be looking for this. "Standardized" I/O ports are only used in some situations, such as hardware that was present on pre-PCI (AT and compatible, etc.) PC hardware. Examples of devices using "standardized" I/O ports are the floppy drive, serial and parallel ports, However, most ports are claimed by plugin cards[which?] you might not have and some[which?] are even assigned via PNP which means that any port could be used for the device in question. If you want access to a device, you will need to look up the details for the device in question, and if some fixed port is involved, it will tell you. It is not technically feasible to have a complete mapping of ports to devices as you won't get access to it.
A few devices[which?] were made cheap and do not decode all address bits of the I/O port in question (only the bottom 12 or 14). That means that there are up to sixteen port addresses mapping to the same device. Similarly, some devices have chosen to avoid conflict with such devices by using a sparse register file. The bottom bits would be defined as constant, and the top bits would instead be used for the index. You would get ports number 0x82E8, 0x84E8, 0x86E8 and so on. Such ISA devices are typically prone to interfering with PCI assigned IO addresses due to their spread.
Modern implementations of old devices (typically IDE and VGA controllers) have an implementation that is mentioned to be plug-and-play with moving registers, but they are still able to listen to legacy ports and respond accordingly.
If you have found a port number and you are still wondering what it's meant to do, here's a list of the most common ports:
|0x0000-0x001F||The first legacy DMA controller, often used for transfers to floppies.|
|0x0020-0x0021||The first Programmable Interrupt Controller|
|0x0022-0x0023||Access to the Model-Specific Registers of Cyrix processors.|
|0x0040-0x0047||The PIT (Programmable Interval Timer)|
|0x0060-0x0064||The "8042" PS/2 Controller or its predecessors, dealing with keyboards and mice.|
|0x0070-0x0071||The CMOS and RTC registers|
|0x0080-0x008F||The DMA (Page registers)|
|0x0092||The location of the fast A20 gate register|
|0x00A0-0x00A1||The second PIC|
|0x00C0-0x00DF||The second DMA controller, often used for soundblasters|
|0x00E9||Home of the Port E9 Hack. Used on some emulators to directly send text to the hosts' console.|
|0x0170-0x0177||The secondary ATA harddisk controller.|
|0x01F0-0x01F7||The primary ATA harddisk controller.|
|0x02F8-0x02FF||Second serial port|
|0x03B0-0x03DF||The range used for the IBM VGA, its direct predecessors, as well as any modern video card in legacy mode.|
|0x03F0-0x03F7||Floppy disk controller|
|0x03F8-0x03FF||First serial port|